Footage shot at 3840x2160@ 23.98 (anafi) @ 100Mbps
Exporting the video after edit (powerDIrector) It seems it creates that artifact.
Settings used on PD:
h.264[/list]
mpeg-4 4k 3840 x 2160/24 (50Mbps)[/list]
Focus on the creek pixelation
https://ibb.co/ZcnqDDT
exported as 3840x2160 25p - no edit, plain
https://youtu.be/KQ0A5KAOBqQ
exported as 4096x2160 24p - no edit, plain
https://youtu.be/eGeXntVdhVI
original-settings-from-drone
https://ibb.co/bNW93xy
exported-video-settings-on-power-director
https://ibb.co/vzYL0Cx
On Reddit somebody mentioned that it could be issue related to transcoding from 100Mbpls(drone) to 50
"Its most likely due to the transcoding of your video editor going from 100 Mbps to 50. There are a few causes. This is what is known as macroblocking. This is caused by too much compression in certain areas and your editor's codec may not be able to compress that area adequately due to limitations of lower bitrate H.264 AVC. It also could be due to the playback function from 4K to 1080 on your screen which compresses it further for Youtube compatibility. You might want to edit and render in a higher bite before converting it to a youtube format for playback, if you do not have a 4K monitor it might make sense to render it in native 1080 if that is the intent for the final playback on youtube, due to bandwidth constraints."
If that is the case HOW can I fix that on PD17 or the software is too weak?
Thank you in advance.
This message was edited 3 times. Last update was at Apr 07. 2019 21:05