|
|
Quote
Hi,
I'm assuming that CAM reports a successful install/re-install etc.?
Others may have some experience that may be helpful, but the rather generic error message doesn't give much to go on.
It will be worth posting a DxDiag for review in case that may show something up, but I would recommend raising a support ticket anyway, as it may be the quickest route to a resolution if the new install has gone awry.
Cheers
PowerDirector Moderator
Yes, it did. I just went ahead and deleted every bit of the program, including all the add ons using Revo Uninstaller. I think that helped with removing all the left over files and clearing out the registry.
I went and downloaded everything again and reinstalled everything and it works perfectly now. Must have been some corrupt files left over from the previouse deletion/installation.
Thank You,
Kirk
|
|
|
Hello!
I searched the forums on this subject and found a thread from 2013, but it was not much help.
I had the PowerDirector 365 subscription installed on a separate drive D and that drive started to fail. I uninstalled PowerDirector Suite and removed the drive. I reinstalled the program onto my main C Drive.
All the programs in the suite launch just fine, but PowerDirector fails to launch and shows this message:
"Cyberlink PowerDirector cannot launch because an important program component is unavailable. Try reinstalling the program"
I am not sure what is missing? I have uninstalled and reinstalled several times and get the same result. I appreciate the help!
Thank You,
Kirk
|
|
|
Scott, i'm wondering the same myself, but going out on limb here and working with Nvidia's Badaboom, you have to disable sli and render using one gpu.
Looks like i'll buy it and test it out....can't have too many editing software programs!!!
|
|
|
