Messages posted by Sonex439

Here's a screen shot. You can see all the transitions. If I edit one of the clips at the left, like cutting off the end of a too-long clip, I can click on the next clip, hold down Shift, and click on the last clip. Now all those clips are selected. If I then drag all of the highlighted clips to the left, and try to create a fade on the shortened clip (by overlapping the two), there is no "Crossfade" option in the resulting dialog.

Mike

I have a movie with lots of crossfades between clips. If I decide to edit one of the clips in the middle, or add a new clip in there, I can't find a way to move the target clip to crossfade with the clip before it, and move all the following clips (with crossfades) with it. When I select the target clip and all the following clips as one unit, and then try to move the clips to the left to crossfade, there is no "crossfade" option. So I would have to RE-crossfade all the follow-on clips!

Did that make sense?

Quote: You probably have a little sliver of video, audio, or static pic out there. Use the keyboard "End" key while in the timeline to find the end. You may need to use keyboard "+" key to zoom in and find sliver. Just delete the little clip if not needed.

Jeff

That did it, thanks! That was one darn small sliver. I had to zoom way in before is showed up.

When I Produce my movie the end result is 2 minutes longer that what is on the timeline. The last 2 minutes is just a black screen. How do I tell PD to end the movie at the end of the video and audio? When I Play from the timeline, the moving cursor keeps going well after the end of the video and audio, so obviously PD does not understand that the movie is over.

Power Director 13, Ultimate. Win7/64bit.

Mike