I have PD14 on both a lap top and desk top. Both are set to 16:9 ratio. I have loaded scanned slide images into a project in the lap top set at 16:9. This is saved on an external hard drive. I have adjusted/reduced the slide images to fit the TV screen limits and saved as 16:9. I have transfeed to project on the desk top also set at 16:9 and everything opens ok with the images set at the tv screen limits. After working on the project I save it still in 16:9 back to the hard drive. When I open PD on the laptop it is still set to 16:9 however when I re-open the project as soon as the images have all been identified and the insertion into the time line takes place the aspect changes on its own to 4:3. This alters all the reduced sized images and if the aspect is then changed back to 16:9 the imges are become completley incorrect. I presume PD is recognising the reduced images as closer to 4:3 than 16:9 and adjusting itself automatically. Is there any way that I can stop this adjustment and why is it not occuring when I load the project to the desk top. General settings for both machines are the same. I wondered about inserting a piece of 16:9 filming at the begining of the time line which could removed when the wole project is completed but feel there should be some way of fixing the aspect whatever the size of the iamnges used. Any advice welcomed. David