I have been adding single image stills to video projects with no issues. When I add a panoramic still the still is pushed down to where the right and left sides of the image are confined in the preview window, causing the height of the image to be only occupying about 20% of the viewable window. It was advised in another thread that I not maintain aspect ratio and when I did that I was able to run the left and right sides of the pan run off the viewable window as I filled the window top to bottom but when ran the video, I got the same terrible pixilation I had before resizing. This pano is 1600 pixels high. I should not be getting this immense drop in image quality. It doesn't happen when I install a single (not stitched pano) image into the video. Any ideas? I want to install a panoramic still then use PD9 software to do the actual pan full screen. My panoramic are very wide and are meant to be scrolled side to side. I would think these wide panos would be ideal in video projects and I hope to add many to future projects.
Thanks in advance
Dell Studio XPS 7100 Minitower:
Phenom II 6 Core 1075T 3.0GHz processor - Black . ATI Radeon HD 5770 1GB GDDR5 graphics card . 12GB DDR3 SDRAM,1333MHz . 300GB 10,000 rpm SATA Hard Drive . 12X Pioneer BluRay Burner . 16X DVD+/-RW . Windows 7 64bit .